Application of a mobile measuring device for the planar evaluation of the current in-situ stress condition in glass

Authors

  • Marcus Glaser Technische Universität Ilmenau Production Technology Group
  • Benjamin Schaaf
  • Mascha Baitinger
  • Barbara Siebert

DOI:

https://doi.org/10.7480/cgc.7.4487

Keywords:

Photoelasticity, in-situ stress condition, load-bearing glass, mobile device, finite element analysis

Abstract

The load-bearing capacity of glass as a structural material as well as sustainability and resistance of a built-in glass against appearing loads and forces is assuming an ever-greater importance. Next to analytical and numerical calculations of maximum load-bearing capacity and the ultimate limit state, there is no generally accepted standardized non-destructive inspection method available, with which it is possible to estimate the prevalent load situation and predominant stress conditions, particularly in relation to mechanical or adhered connections. Within the research project “BiGla”, a measuring instrument based on photoelasticity was developed, which enables to measure and monitor occurring load states during the installation process, as well as the utilization of glass components subjected to significant load changes during their life cycle. Based on the combined examination of photoelasticity and its synergism with the finite element analysis it becomes possible to transfer qualitative measurement results into quantitative evaluations of predominant stress conditions. Achieved results, gained during experimental investigations under laboratory conditions, as well as during extensive field tests, are presented in this publication.

challenging glass

Published

2020-09-04

Issue

Section

Numerical Modeling & Experimental Validation